Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.
Audi A3 with S-tronic DSG gearbox hesitates, shudders or creeps awkwardly when pulling away. Identical to VW DSG issue across VAG group. This fault code is stored when the engine control unit detects a specific fault condition. Common causes include sensor failures, wiring faults, and component wear. Always read additional fault codes before replacing parts — multiple codes together provide a clearer diagnosis. Clear the code after repair and test drive to confirm the fault does not return.
Based on 0 driver confirmations
No commonly reported misdiagnoses for this fault yet. If you have replaced a part that did not fix this Audi problem, submit a wrong diagnosis report — it helps other drivers avoid the same costly mistake.
Hesitation got worse then started getting fault codes for the mechatronic unit. Audi dealer replaced the mechatronic unit under extended warranty. Not cheap out of warranty — about £1,400 — but covered in my case. Push Audi hard if yours fails early.
Parts replaced: Mechatronic unit
Hesitation and occasional shudder from rest. Audi say DSG fluid is lifetime but it's not. Had it serviced by a VAG specialist at 38k. Old fluid was dark and smelled burnt. New fluid transformed the gearbox — smooth pull away, no hesitation.
Parts replaced: S-tronic DSG fluid and filter
Your real-world fix helps thousands of drivers worldwide. Takes 2 minutes.