⚠️ Important Notice

By accepting, you confirm you have read and agree to our Terms of Use and Privacy Policy.

Your IP address and browser information will be recorded as proof of this acknowledgement. This data is retained for 12 months.

🟡 PARTIAL: Isuzu D-Max 1.9 DDi AdBlue NOx sensor fault — Isuzu D-Max 2018 | MyCarFault
🟡 PARTIALLY SOLVED 0% Partially solved · Some fixes work, not all

🟡 Isuzu D-Max 1.9 DDi AdBlue NOx sensor fault

Isuzu D-Max 2018
On This Page: 🔧 All Repairs ⚠️ Avoid These 📖 Repair Guides
⚡ Quick Summary
Severity Level
Low
Safe to Drive?
⚠️ Drive with Caution
Safety Impact
Indirect risk — worth monitoring, not urgent
Urgency Level
🟢 Low Priority

Engine management light and AdBlue warning on the Isuzu D-Max with the 1.9 DDi engine. The NOx sensor downstream of the SCR catalyst deteriorates with heat cycling, causing incorrect AdBlue dosing and triggering the warning. The sensor is expensive but replacement resolves the fault permanently. Ensure the AdBlue system has been purged after sensor replacement to remove any contaminated fluid in the lines. Use only ISO 22241 AdBlue.

Repair / Solution

No confirmed fixes yet. Share yours below.

⚠️ Wrong Diagnosis?

No commonly reported misdiagnoses for this fault yet. If you have replaced a part that did not fix this Isuzu D-Max 2018 problem, submit a wrong diagnosis report — it helps other drivers avoid the same costly mistake.

🚗 More About This Vehicle

📋 All Isuzu D-Max fault reports → 🚘 All Isuzu fault reports → 🔧 Browse all fault reports →

📖 Related Repair Guides

mechanical · 1
How to check and top up AdBlue on a diesel vehicle
15 minutes

Help other owners by sharing your experience.

Your real-world fix helps thousands of drivers worldwide. Takes 2 minutes.

✅ Submit a Fault ❌ Wrong Diagnosis?
🔧
Usta
● Online